after the pull but before the update ...

[Robert P. J. Day]

On Wed, 7 Oct 2009, Adrian Buehlmann wrote:

> On 07.10.2009 01:09, Adrian Buehlmann wrote:
> > On 06.10.2009 20:20, Robert P. J. Day wrote:
> >> On Tue, 6 Oct 2009, Adrian Buehlmann wrote:
> >>
> >>> On 06.10.2009 19:15, Robert P. J. Day wrote:
> >>>>   WRT p. 20 of the hg book, i can see the clear distinction
> >>>> between doing a pull and doing an update, but is there a command
> >>>> that will show me that (pulled but not yet updated) content?  i'm
> >>>> sure it will be explained at some point later in the book, but it
> >>>> would be useful to show how to do that when introducing that
> >>>> two-phase operation.
> >>> maybe this could be helpful:
> >>>
> >>> hg log -r .:
> >>>
> >>> shows all changesets from the range parent..tip
> >>>
> >>> http://www.selenic.com/mercurial/hg.1.html#revisions
> >>   very close.  technically, i was asking for the open interval
> >> (parent:tip], rather than [parent:tip], but that's close enough,
> >> thanks.
> >
> > I just discovered -P (--prune):
> >
> > -P --prune         do not display revision or any of its ancestors
>
> Put the following in your $HOME/.hgrc file:
>
> [alias]
> new = log -P .
>
> and you can just enter 'hg new' instead

  yes, that's what i was after, thanks.  more silly questions coming
shortly, i suspect.

rday
--

========================================================================
Robert P. J. Day                               Waterloo, Ontario, CANADA

        Linux Consulting, Training and Annoying Kernel Pedantry.

Web page:                                          http://crashcourse.ca
Twitter:                                       http://twitter.com/rpjday
========================================================================